| Applications: |
LP and Natural Gas, Flammable Liquids, Instrumentation, Refrigeration, Power Steering, Hydraulic and Pneumatic Systems. |
Used With: |
Copper, Brass, Aluminum and Steel hydraulic tubing that can be flared. |
| SAE Rating: |
N/A |
Conformance: |
Meets specifications and standards of ASA, ASME, SAE and MS (Military standards). |
| Vibration: |
Good resistance – use long nut when greater vibration resistance is required. |
Temperature Range: |
-65°F to +250°F (-53°C to +121°C) range at maximum operating pressures |
| Tolerance: |
+/- .03 on all dimensions. Dimension data can change without notice. Please call us when dimensions are critical. |
Lead Free: |
Not Lead Free |
| Working Pressure Ranges: |
- Temperature and type of tubing used are important factors. However, the following table is a good guide for proper selection. Temperature 730F with copper tubing:
|
| Assembly Instructions: |
- 1) Cut tubing to desired length. Make sure all burrs are removed and ends are cut square.
- 2) Slide nut on tube. Threaded end “A” of nut must face out.
- 3) Flare end of tube with a 450 flaring tool.
- A) Measure flare diameter
- B) Examine flare for excessive thin out.
- 4) Lubricate threads and assemble to fitting body. Nut should be turned hand tight.
- 5) Tighten assembly with wrench until a solid feeling is encountered. From that point, apply a one-sixth turn.
- Note: Do not over-torque as it may damage the fitting or split the tubing at the flare.
|
|
| Tube OD |
1/8″ |
3/16″ |
1/4″ |
5/16″ |
3/8″ |
7/16″ |
1/2″ |
5/8″ |
3/4″ |
| Thread Size B |
5/16-24 |
3/8-24 |
7/16-20 |
1/2-20 |
5/8-18 |
11/16-16 |
3/4-16 |
7/8-14 |
1-1/16-14 |
| Crossover Series: |
| 43 |
403 |
43A |
|
| Part Number |
Male Flare x Male NPTF |
A |
Hex |
Approx. Weight
(Lbs.) |
10131*
(10-131) |
1/4″ x 1/8″ |
1.06″ |
0.43″ |
0.04 |
| 10256WC |
1/4″ x 1/4″ |
1.24″ |
0.60″ |
0.04 |
10133*
(10-133) |
3/8″ x 1/4″ |
1.31″ |
0.62″ |
0.08 |
| 10132 |
5/16″ x 1/8″ |
1.14″ |
0.50″ |
0.04 |
* Note: Ball & Spring position may be reversed to change flow/check position. Min. working pressure 3 PSI.
Reviews
There are no reviews yet.